Run-Stop Electric 4-way fuel valve ETR G4

Brand: ETR
|
€297,35 €545,50
In stock (3 Products)
On stock
Ordered before counting..., delivered tomorrow
Article code ETR-12
EAN
Information

 

 G4 2/4 way valve for safe engine shut-off

This G4 Diesel Fuel Stop Solenoid valve, immediately and safely, shuts down engines by reversing fuel flow and creating a vacuum in the injection pump. 

  • This 2/4 Way Solenoid Valve will very reliably stop a diesel engine in any situation.
  • Because, contrary to normal stop solenoids, which act on the pump stop lever and
    become ineffective whenever the fuel rack sticks, this valve acts directly on the fuel
    supply to the pump.
  • In stop position the suction side of a fuel supply pump and its output side are
    reversed, which then creates an instant vacuum in the fuel injection pump galley, the
    engine speed immediately drops to zero.
  • The same valve can be used in “energized to run” or “energized to stop” mode
    simply by reversing the connecting hoses.
  • The installation of the G4 valve is quite simple. Attached description illustrates the
    connecting method for both modes, which are also marked on the valve itself.

Working Principle : 2 position 4 way solenoid valves with sleeve
Supply voltages

G4 – 12 Volt : 10.0 – 14.4 VDC (- 40°C to +100°C)
Current consumption
G4 – 12 Volt : 0.70 – 1.3 Amp.
Max. Pressure : 4.5 bar at injection pump
Flow rate : min. 360 litre/hour at 1.3 bar
Duty Cycle : 100% duration
Temperature range : - 40°C to +130°C
Vibration shock : up to 20 G, @ 50 – 500 Hz
Electrical connection : Cable 200 mm long with Packard connector
EC 1300 Mating connector EC 1310 included
Insulation class : H – tested at 1600 VDC against ground
Certification : CE, according EN 50082-1, EN 50082-2 and
EN 50081-1, EN 50081-2

G4 – 24 Volt : 20.0 – 28.8 VDC (- 40°C to +100°C)
Current consumption
G4 – 24 Volt : 0.41 – 0.72 Amp.
Max. Pressure : 4.5 bar at injection pump
Flow rate : min. 360 litre/hour at 1.3 bar
Duty Cycle : 100% duration
Temperature range : - 40°C to +130°C
Vibration shock : up to 20 G, @ 50 – 500 Hz
Electrical connection : Cable 200 mm long with Packard connector
EC 1300 Mating connector EC 1310 included
Insulation class : H – tested at 1600 VDC against ground
Certification : CE, according EN 50082-1, EN 50082-2 and
EN 50081-1, EN 50081-2

Didn't find what you're looking for?
Let us help!
By using our website, you agree to the usage of cookies to help us make this website better. Hide this message More on cookies »